Resources · Roofing
Roof replacement cost in Austin, TX: a planning guide
(737) 418-8832 · Mon–Fri 8am–5pm · Sat 10am–3pm · Sun closed
For a one-story Austin-area home with a 2,000-square-foot footprint and a moderate pitch, our planning range for an architectural shingle roof replacement is about $12,000 – $13,500, with tear-off of one layer included. Standing seam metal on the same house plans out at about $17,500 – $19,000 in Galvalume or $20,500 – $23,000 in a painted color. These are planning numbers from the same formula as our roof cost calculator, not a quote. Your written price comes after we inspect and measure the roof.

How a house becomes roofing squares
Roofing is priced by the square: 100 square feet of roof surface. Most people know their home's square footage, not their roof area, so the planning math works like this:
- 1Start with the ground-floor footprint plus any attached garage.
- 2Add about 10 percent for eaves and rake overhangs beyond the walls.
- 3Multiply by a pitch factor, because a steeper roof has more surface over the same footprint.
- 4Divide by 100 to get squares, then allow about 10 percent for cut waste on material.
| Pitch | Factor used |
|---|---|
| Low (up to 4/12) | 1.06 |
| Moderate (5/12 to 6/12) | 1.12 |
| Steep (7/12 to 9/12) | 1.20 |
| Very steep (10/12 and up) | 1.32 |
The example house works out to about 25 squares of roof. A measurement during the inspection replaces this estimate with the real number.
Planning rates and a worked example
| Material | Planning rate per square, tear-off included | Example: 2,000 sq ft, 1 story | Same house, 2 stories |
|---|---|---|---|
| Architectural shingles | $450 – $500 | $12,000 – $13,500 | $13,000 – $14,500 |
| Standing seam metal, Galvalume | $650 – $700 | $17,500 – $19,000 | $19,000 – $20,500 |
| Standing seam metal, painted color | $750 – $850 | $20,500 – $23,000 | $22,000 – $25,000 |
Two-story homes take more staging and safety setup, so the planning range is about 8 percent higher for the same roof area. Tile, stone-coated steel and low-slope systems are priced by quote after an inspection. For your own numbers, use the calculator.
What moves the price up or down
- Extra layers. The planning rate includes one layer. Georgetown, for example, requires tear-off when there are already two or more layers.
- Decking. Soft or rotten boards found during tear-off are replaced before the new roof, priced per sheet in your estimate.
- Roof shape. Valleys, hips, dormers and walls add cuts, flashing and labor.
- Ventilation. Intake and exhaust may need to be brought into balance; see our post on attic ventilation.
- Penetrations. Chimneys, skylights and pipe boots each need flashing.
- Access. Tight lots, landscaping, pools and steep driveways change how materials are staged.
- Permits and code items. Rules vary by city. Georgetown lists a $60 re-roof permit; Round Rock does not require a permit for a residential re-roof, and Cedar Park does not for a non-structural one. Each city page has the details.
Insurance and your deductible
When hail or wind damage is covered by your policy, the insurer pays for the covered damage under its terms and you pay the deductible. Texas law does not allow a contractor to offer to waive or rebate your deductible; the City of Georgetown repeats that warning on its roofing page. If you are upgrading to an impact-rated shingle, the Texas Department of Insurance says each insurer sets its own premium credit, with Class 4 receiving the highest. See insurance restoration.
Sources (retrieved November 14, 2026). Rules change, so confirm with the agency before work starts:
- Texas Department of Insurance: Impact-resistant roofing credits ↗
- City of Georgetown: Re-roofing permits ↗
- City of Round Rock: Homeowner projects ↗
Paying for a new roof
Financing may be available through our lending partners, subject to credit approval. See roofing financing and the New Roof Now, Pay Later program.
What a Ridgepoint written estimate includes
- Measured roof area and pitch, with photos
- Tear-off, disposal and the decking allowance
- Underlayment, drip edge, valley and wall flashing, and ventilation
- The roof covering by product line and color
- Permit and HOA steps for your address
- Our 10-year workmanship warranty on the full replacement, with the manufacturer's material warranty listed separately
Ready for a real number? See roof replacement for the process, or the local pages for Georgetown, Round Rock and Cedar Park.
Frequently asked questions
Is this a quote?
No. These are planning ranges from typical re-roof rates and a simple roof-area formula. Ridgepoint gives a written price only after inspecting and measuring your roof.
Does the planning range include tearing off the old roof?
Yes, one existing layer. More layers, or decking that needs replacing, are priced after the inspection.
Why does pitch change the cost so much?
A steeper roof has more surface over the same footprint and needs more safety setup. In the factors above, a very steep roof has about a quarter more surface than a low-slope roof on the same house.
Will insurance pay for my new roof?
Only for damage your policy covers, under its terms, minus your deductible. A contractor cannot legally waive or rebate the deductible in Texas. We document damage for the claim and work from the adjuster's scope.
Our promise
Ridgepoint Workmanship Guarantee
A 10-year workmanship warranty on full roof replacements, and up to 1 year on repairs.
- 10-year workmanship warranty on full roof replacements.
- Up to 1 year of workmanship coverage on repairs.
- This warranty covers our workmanship. Manufacturer or material warranties are separate and not part of it.
Get a written roof price
Free inspection and written estimate. Use the form or call (737) 418-8832.